Kalfire G160/41F, Инструкция пользователя

Страница: 16 / 36

16
3. Walk around the appliance at a
distance of 3 to 4 metres to measure
the RFCK. If the RFCK shows a value
of 4, the transmission strength of the
remote control is good. If the value
shows as 2 or 3, the RFCK values are
acceptable. Transmission strength is
insufficient at a RFCK value of 1.
4. Confirm with to exit the menu.
4.5 Switching the appliance on and off
Carry out the following steps to turn
the appliance on or off:
1. Press until the >OK< icon in the
display appears and starts to flash.
2. Continue to press and then press
briefly on to activate the ignition
programme.
3. Release both buttons.
The word >WARM< will flash
at the top left of the display as
confirmation of activation.
4. Wait a number of seconds until
you hear a beep and the word
>WAIT< appears. The ignition
programme will start and the
burner will automatically ignite after
approximately
20 seconds.
5. Wait until you hear a second beep.
The word >WAIT< will stop flashing
after the ignition programme.
6. The gas fire flame is alight and
operational.
7. Press for approximately two seconds
to extinguish the gas fire flame.
4.3 Setting day and time
Setting day and time.
Carry out the following steps to change
the day and time settings:
1. Hold down the P button until the
time display starts flashing.
2. Change the hour with the + or ­
button and confirm the change by
pressing the centre button.
The minutes will then begin to flash.
3. Change the minutes with the + or ­
button and confirm the change by
pressing the centre button. The
number indicating the day of the
week will then begin to flash
(1 = Monday).
4. Change the day with the + or ­ button
and confirm the change by pressing
the centre button.
5. To exit the parameters menu, press P .
6. Wait for 30 seconds while the
information is transmitted.
4.4 Checking transmission strength
Carry out the following steps in order
to modulate transmission strength
between gas fire and the remote
control.
1. Press P until the transmission
strength flashes at the top left of the
display.
2. Press the right button until RFCK
appears in the display.