background image

9

CLEANING

Clean with cold water and a soft bristle brush. 
Do not use soaps or detergents. Do not 
expose to petrol, diesel, oils or chemicals of 
any nature.

Failure to follow these instructions may impact 
the performance of your rooftop tent and 
cause damage.

STORAGE

If you have to pack your rooftop tent up wet - 
it is essential that the rooftop tent is unpacked 
and allowed to dry fully as soon as possible. 
Failure to do so will result in damage to the 
rooftop tent fabric, waterproofing and may 
cause mildew. 

Although the PVC cover material itself is 
waterproof, there is the chance of water 
ingress from the tent not being tucked in 
properly or the buckles not done up tight 
enough. We recommend to check the inside 
of the rooftop tent’s bag to ensure no water 
has made its way in. If there is moisture, the 
rooftop tent needs to be allowed to dry out.

STRUCTURE

Kakadu

 rooftop tents have been designed for 

general outdoor use under normal conditions. 
Always ensure that all ropes and pegs are 
attached and secured at all times. 

To avoid chances of personal injury 
and/or property damage, Kakadu

 

highly recommends the rooftop tents 
should NOT be erected during windy 
conditions. 

Damaged caused by wind and/or 
adverse weather will not be covered 
under warranty.

FITTING

Kakadu

 recommends this rooftop tent 

to be installed with 2-3 people. It is also 
recommended to use an experienced 
aftermarket 4X4 accessories fitter to mount 
the rooftop tent to your rack. All mounting 
hardware on both the rooftop tent and roof 
rack should be checked regularly to ensure 
they are always mounted securely. 

NOTE: Kakadu

 takes no responsibility 

for the fitment of the rooftop tent to any 
vehicle or roof rack.

Prolonged travelling on uneven, rough 
or corrugated terrain will require more 
frequent inspections 

The brackets have been carefully designed 
to fit most common roof rack configurations. 
However, the increasing amount of roof rack 
designs available in the market makes it 
difficult to supply a bracket to fit all racks. It is 
recommended to discuss specific mounting 
options and load capacities with a roof rack 
specialist. 

WATERPROOFING

The raw materials that have been used on this 
rooftop tent have been designed to withstand 
most weather events. The water repellent 
coating and sealed seams provide protection 
from bad weather. However, wind-driven rain 
can cause water ingress when windows and 
doors are open. We recommend to close 
all windows and doors in the case of bad 
weather. If you find that water is coming 
through a zipper, a softened wax stick can be 
used to rub over that area. 

USING THE OPTIONAL ANNEXES 

 

The annexes available for purchase will 
provide a sheltered/protected area underneath 
the rooftop tent.  

Disclaimer:

 Any addition applied onto the 

vehicle’s roof changes the loading and 
handling of the vehicle. Kakadu

 disclaims all 

responsibility in the occurrence of accidents 
due to improper use, lack of maintenance 
and not ensuring the rooftop tent has 
been securely fitted. Kakadu

 shall not be 

liable for any damages whether they are 
special, indirect, incidental, accidental or 
consequential.

Содержание BIRDSVILLE













Отзывы: