KAKA Industrial CS-12, Руководство по эксплуатации

Страница: 7 / 25

from your dealer. The coolant must be diluted in wear in a ratio between 1:10 and 1:20, depending on the
kind of material. Add the oil slowly to the water while stirring it continually. The filler cap is positioned at
the rear of the machine base. The capacity of the tank is 10 litres.
The coolant circulates and for the larger part flows back into the tank. After some time
The coolant wiil be used up completely and the tank will have to be filled again. A filter is also
incorporated in the coolant circuit.
For general metal material (e.g. steel, copper), it is recommended to use BP-70 coolant.
Warning: Some material has fire hazards, e.g. Magnesium. Care must be taken when cutting such
material. Special coolant must be used for these material. Please get detailed information from
professional coolant supplier for special coolant.
-When adding coolant, attention should be taken that the coolant level should not access the line marked
on the coolant container.
4.4 Electricity
Have the electrical connections made by a qualified installer. Connect the machine in accordance with
the electrical diagram applying to your machine.
Electrical installations should be always performed by authorized electricians.
1)Make sure that the correct voltage is supplied to the machine.
2)Set up the electrical connections according to the attached circuitry. Connect the electricity on the
main line’s automatic circuit breaker.
3)Make sure that the circular saw has the correct rotation direction.
Warning: Note the earth screw!
Saw motor
Two-speed pole changing motors are suitable for one mains voltage only. Therefore check whether the
voltage indicated on the motor plate complies with the local mains voltage.
• Check whether the direction of rotation of the saw pitch corresponds to the arrow on the safety guard.
•If the motor rotates in the wrong direction two phases wires must be switched.
Overvoltage protection device shall be provided in the power supply line by the end user.
5 Operation
When operating at the first time, please check the back extension spring whether it is fastness, whether
it is fastness between handle switch and handle .You must move the head of machine and protection of
cutter up and down . Make sure they can convenient to open and close. Then you can operate it as
follow :
5.1 Selection of the sawblade
After years of research we recommend you to use only Time winner saw blades. These HSS saw blades
are of top quality and are made of the base material DMO 5, These saw blades have undergone a