KAKA Industrial CS-12, Руководство по эксплуатации

Страница: 10 / 25

5.4 Installing and replacing the saw blade
• Set the main switch in the off position.
• Put the saw head in the upper position.
• Open the guards (fig- 5.03A).
• Release the socket head screw M8 of the saw spindle
(fig. 5.03B) and remove the saw flange.
• Remove the saw blade.
• Carefully clean the saw spindle and the saw flange.
• Installing is done in reverse order. Pay attention to the direction of rotation of the sawblade. Make sure
the saw blade is placed flush against the flange of the saw spindle. Check the setting of the sawing
depth {see chapter 4.2}. Do not forget to close the safety guard.
5.5 Saw feed
Manual saw feed
The saw feed is determined by hand. The saw is lowered onto the material by means of the handle. Press the saw
blade firmly onto the material, without using unnecessary force. When the saw pressure is too high this can cause
the saw to break; when the saw pressure is too fow, the saw will rapidly go blunt.
5.6 Sawing speed
The saw speed wilt be selected by the switch (fig, 5.04A)
The following cutting speeds are possible:
CS-315 and CS-350 LOW SPEED SAWING SPEED POS.1:18.5M/MIN IN POS.2: 37M/MIN.
CS-315 and CS-350 HIGH SPEED SAWING SPEED POS.1:37M/MIN IN POS.2: 74M/MIN.
Every material has it's own cutting speed. Below advice for some materials;
18, & 36r/min > For steel alloy e.g. stainless steel
Fig.5.03
Fig 5.04