KAKA Industrial CS-12, Руководство по эксплуатации

Страница: 6 / 25

4.1 Installation mounting
Unpack the machine.
• Determine where the sawing machine will be placed, in doing so take into account the feed and
discharge of materials, optional built-on accessories, maintenance and repairs.
• Remove the plastic plug from the saw head (fig. 4.01 B). If so required a lifting hook M20 DIN 580 can
be screwed into the hole.
• Race the saw unit - if necessary by means of hoisting equipment - on the machine base (cover at the
rear) and attach each other.
•Secure the machine on the floor. The necessary holes have already been made in the machine base.
• Install the handle in the saw head and lock it(fig 4.01 A).
• Install the 3 short handles in the boss of the machine vice,
• Install the stretcher in the clamp.
• Slide the plastic tube coming from the cooling pump onto the tap which is positioned on top of the
protective guard of the saw unit (fig 4.02A).
• Check on the level gauge of the saw head whether it contains sufficient oil. if necessary fill up (fig. 4.01,
see arrow).
• Install the cover at the rear of the machine base.
• Install the saw blade (see chapter 5.4)
4,2 Non-recurrent adjustment
This adjustment is concerning the LOWEST POSITION of the saw head. Follow the instruction on the
saw flange (fig. 4.03, see arrow). This instruction is also important when changing the saw blade.
4.3 Coolant
The use of proper cutting fluid is essential to obtain maximum efficiency from a band saw blade. The
main cause of tooth failure is excessive heat build-up. This is the reason that cutting fluid is necessary
for long blade life and high cutting rates. Cutting area and blade wheels should be kept clean at all time.
The rate of coolant flow is controlled by the stop valve lever (J) in Fig.4.02.which directs the coolant onto
the blade . The lever (J) is shown in the off position.Circulation system
Fill the tank with coolant. Use sawing coolant and absolutely NO cutting oil. recommends oils, available
Fig 4.02
Fig 4.03
When you put on
new blade reset
adjusting screw.
J