KAKA Industrial 173123, Руководство по эксплуатации, Страница: 5 / 16

— 5 —
Operation Manual W-4816Z
KAKA Industrial®
Adjusting the Stop Rod
The stop rod is used for repeat
bending when you want the bending
leaf to stop at the same
position each time.
1. Loosen the stop nut and washer
and make your bend, stopping at the
top of the bend.
2. Tighten the nut and washer up to
the stop block.
3. The bending angle can now be
repeated until reset by the operator.
Adjusting the Setback
Setback is the distance from the front
edge of the finger to the front edge of
the clamp block as shown in picture.
This distance is determined by the
gauge (thickness) of the piece part
and inside radius of the bend. The
setback is typically 1-1/2-2 times the
material thickness. (Pic.4)
1. To adjust, make sure all the fingers
are properly aligned to each other and
the hold down assembly is not locked
in the down position.
2. Loosen the setscrews (C) at the
back of the hold down assembly (Pic.
5).
3. Insert a tool, such as an allen
wrench, into one of the spoke holes of
the eccentric hub and rotate it, which
moves the hold down assembly either
forward or back.
4. When the fingers are at the correct
setback distance and parallel to
the clamp block edge, tighten the
setscrews (C).