KAKA Industrial 173123, Руководство по эксплуатации, Страница: 4 / 16

— 4 —
Operation Manual W-4816Z
Model W-4816Z
3. FLOOR: This tool distributes a
large amount of weight over a small
area. Make certain that the floor is
capable of supporting the weight of
the machine, work stock, and the
operator. The floor should also be
a level surface. If the unit wobbles
or rocks once in place, be sure to
eliminate by using shims.
4. WORKING CLEARANCES: Take
into consideration the size of the
material to be processed. Make sure
that you allow enough space for you
to operate the machine freely.
Anchoring the Machine
1. Position the machine on a firm and
level concrete floor.
2. Maintain a safe operating distance
around the machine.
3. Anchor the machine to the floor, as
shown in the diagram, using bolts and
expansion plugs or sunken tie rods
that connect through holes in the base
of the stand.(Pic.1)
Attaching the Counterweight
1 . H a v e a h e l p e r h o l d t h e
counterweight.
2. Back off the two hex bolts and
slide the counterweight rod into the
receiver pipe.
3. When the rod is flush with the
bottom of the receiver, tighten the hex
bolts.(Pic.2)
NOTE
DO NOT use the counterweight
handle to raise the bending leaf.
You may damage the hinges or the
bending leaf.
Attaching the Stop Rod
1. Remove the nut and washer and
slide the stop rod into the stop block
(A) the install the washer and nut
back onto the rod.
2. Remove the cotter pin and push the
short end of the stop rod into the tab
(B) on the bending leaf and secure
with the cotter pin. (Pic.3)