Kaivac Autovac, Руководство оператора и каталог запасных частей

Страница: 14 / 24

kaivac
cleaning
systems
TM
kaivac
cleaning
systems
TM
P a g e ǀ 1 4
1-800-287-1136
Customer/Technical Support P a g e ǀ 1 4
3.3 A
Uto
v
AC
o
peRAtion
3.0 Operation
The AutoVac feature is a walk-behind system for high speed cleaning of hard surface areas. It cleans as
well and as fast as a walk-behind or ride-on auto scrubber at a fraction of the cost.
After the unit has been filled with the appropriate
amount of water/solution, ensure that the AutoVac
Connector on the side of the cart is connected in place.
Lower the Microfiber Pad and Wide-area Squeegee Head
by lifting the left Strap on the rear handle to unsnap it,
and lower the pad and Squeegee Head.
Reattach with next button snap to hold the
Strap in place.
To begin cleaning floor area with AutoVac:
Use Thumb Throttle to dispense solution
through the Spigot. Turn dial on Thumb
Throttle to number that corresponds to
your applicable floor type.
TIP: T O USE UP THE SOLUTION IN THE PAD, TURN
THE THUMB THROTTLE TO OFF APPROXIMATELY
50’ IN ADVANCE OF FINISHING THE FLOOR
.
CAU
TIO
N:
Kee
p in
OFF
pos
ition
whe
n no
t in
use
1
3
2
4
Aut
o V
ac
OFF
Walk back and forth across the area to be cleaned, using
a three point turn approach when reaching turns, as
detailed below.
Once complete, lift the left Strap to raise the Spreader Pad
and Squeegee Head and snap into place.
Use included Vacuum Tool to pick up any remaining liquids
or drips on the floor.
Walk forward
to end of area
being cleaned.
Continue
turn. Overlap
previous pass.
Pull back
and begin
turn.
Begin turn.