Page 23
KRSD series
Press “Up” or “Down” to move the black cursor to the line that you want to modify and then press
“Enter”. Use “Right” to reach the position to modify and “Up” or “Down” buttons to modify data.
Press “Set” to confirm and save the data after modification.
c. Customer parameters
1
）
Parameter Modification
NOTE: The Customer and Factory Preset Parameters cannot be modified during running and stop
delay status.
The Customer Parameters can be read and modified with the same method of the running
parameter review mentioned above. For example, to modify BLOCK LOAD PRESSURE, the steps
will be as follows:
Press “Up” or “Down” to move the black cursor to the ‘CUSTOMER PARAMETER’ menu and then
press “Enter” to pop up the following menu:
Press the “Enter” again to pop up the following menu:
The CUSTOMER PARAMETERS can be read now without pressing “Enter”. When pressing “Enter”
the following interface will pop up and the password will be required (9999).
NOTE: Customer Password can be modified in the CUSTOMER PARAMETER menu.
SET P, T
SET TIME
OPERATION MODE
BLOCK PARAMETER SET
LOADING P
0.8 MPa
UNLOADING P
0.6 MPa
FAN START T
0080˚C
FAN STOP T
0070 ˚C
ENTER PASSWORD
****
