Kaiser Baas TRAIL, Руководство пользователя

Страница: 8 / 19

BATTERY CHARGING 11 - ENG
To charge the Drone Battery
1.
Remove the battery from the Drone by sliding it
out of the Drone battery compartment.
2.
Connect the USB wall charger (not included)
to the Micro USB charging port on the battery
using the supplied charging cable.
3.
The USB Charging Cable features a red LED
indicator light that will turn off when charging
is complete. While it is charging the light will
be ON.
4. A full charge cycle will take approximately 2-3
hours by 1A charger adapter as the battery
capacity is 7.5V 850 mAh.
Low Battery
The Trail drone is also able to return to its home
point when the battery level is low when the drone
is on the GPS mode. In the normal mode, the
Drone LED Lights will flash when the drone is in
Low Power Mode. When the LEDs are flashing you
should bring the Drone to a complete stop.
1
2
SET UP & INSTALLATION 12 - ENG
Rotor Blades Assembly
It is important that only Kaiser Baas Trail Drone
Rotor Blades are fitted to the Trail Drone. Never
use any third-party accessories or tools.
Your Drone will come ready to fly with Rotor
Blades attached. If you need to replace them,
please refer to the following guide:
Disassembly
Use the provided screwdriver to untighten the
screw in an anti-clockwise direction.
Remove the Rotor Blade by pulling up and off
the motor axis bar.
Assembly
Insert the Rotor Blade onto the motor axis bar.
Only install the Rotor Blades to the corresponding
clockwise/anti-clockwise motor. A letter is
marked on each blade to indicate which motor
it should go on. Incorrect installation will cause
severe instability. Refer to the diagram.
Use the provided screwdriver to tighten the
screws in a clockwise direction.
[WARNING] Never use Rotor Blades with any
signs of damage or wear and tear. This includes
chips, scratches and cracks. Damaged Rotor
Blades can cause the Drone to fail in- flight and
may result in damage to persons or property.
[WARNING] Never touch the Drone or the Rotor
Blades when the motors are spinning.
Rotor guard installation
It is highly recommended to install the Rotor
Blade Guards before using the Drone to
ensure safety.
Failure to land the Drone when the Low Battery
signal starts flashing may cause a sudden loss
of power endangering persons, property and
the Drone.
Ensure the Drone is OFF prior to installation of
modules.