Page 10
Unit
Specifications
and Featu
res
To operate your unit manually:
1. Open the front panel of the indoor unit, use the
supporting rod to prop up the panel.
2. Locate the
MANUAL CONTROL
button
on
the right-hand side of the unit.
3. Press the
MANUAL CONTROL
button
one
time to activate FORCED AUTO mode.
4. Press the
MANUAL CONTROL button
again
to activate FORCED COOLING mode.
5. Press the
MANUAL CONTROL
button
a third
time to turn the unit off.
6. Release the supporting rod,close the front panel.
CAUTION
The manual button is intended for testing purposes
and emergency operation only. Please do not use this
function unless the remote control is lost and it is
absolutely necessary. To restore regular operation,
use the remote control to activate the unit. Unit must
be turned off before manual operation.
Manual Operation(without remote)
CAUTION
Do not put your fingers in or near the blower
and suction side of the unit. The high-speed
fan inside the unit may cause injury.
Fig. B
Fig. A
Deflector
rod
NOTE:
Do not move louver by hand. This will
cause the louver to become out of sync. If this
occurs, turn off the unit and unplug it for a few
seconds, then restart the unit. This will reset the
louver.
Range
The horizontal angle of the airflow must be set
manually. Grip the deflector rod (See
Fig.B
)
and manually adjust it to your preferred direction.
For some units,
the horizontal angle of the airflow
can be set by remote control. please refer to the
Remote Control Manual.
Setting horizontal angle of air flow
Setting vertical angle of air flow
While the unit is on, use the
SWING/DIRECT
button on remote control to set the direction
(vertical angle) of airflow. Please refer to the
Remote Control Manual for details.
NOTE ON LOUVER ANGLES
When using COOL or DRY mode, do not set
louver at too vertical an angle for long periods
of time. This can cause water to condense on
the louver blade, which will drop on your floor
or furnishings.
When using COOL or HEAT mode, setting the
louver at too small an angle can reduce the
performance of the unit due to restricted air flow.
NOTE:
According to the relative standards
requirement
,
please sets the vertical air flow
louver to its maximum angle
under heating
capacity test
.
Setting Angle of Air Flow
•
Manual control
button
Supporting rod
(located on the
left or right,
model dependent )
AUTO/COOL