Kaindl KSS, Руководство по эксплуатации

Страница: 8 / 9

Correct position: Saw blade
sharpening
3. Sharpening of saw blades
The new type of the supplied diamond wheel sharpens all saleable cutting materials. Therefore it is not necessary
to change the grinding wheel for sharpening different saw blades (HSS chrome-vanadium or carbide).
Open the adjustment screws (11) and place your drill machine in correct position:
saw blade sharpening
3.1 Sharpening of inside tooth
For adjusting the saw blade, shift both stop dogs in the way that
the tooth to be sharpened is in a 90 ° angle to the adjustment
slots (1). One stop dog always serves as pivot, the other as
stop dog.
Fix the saw blade with magnet (2) (picture 5).
Advise: Check if the saw blade can be turned easily on the support,
if not, please use the supplied saw blade sliding base (12)
Open the ball fixation screw (10) of the ball joint (9)
and place the grinding wheel parallel to the tooth to
be ground. Fix the ball joint (9) with the ball fixation screw (10)
in this position. By use of the feeding screw (8) move the
grinding wheel to the tooth, till the inside tooth is sharpened correctly.
Now mark this sharp tooth with a felt pen.
Then turn the saw blade over the stop dog, away from the grinding wheel (picture 6) . Now one tooth after
another is sharpened until you come back to the marked tooth. In case some teeth are not sharpened, feed
a little more with the grinding wheel towards the tooth and repeat the complete operation.
Advise: Before you turn on your drill machine, simulate the grinding operation without having connected
your drill machine to electric current. So you can check again the adjustments done, for drills or saw blades
Picture 5 Picture 6
Pivot
Stop dog
Stop dog
Pivot