Kahn Easidew I.S., Руководство пользователя

Страница: 14 / 31

Easidew I.S. User’s Manual
8 97099 Issue 13.4, August 2015
INSTALLATION
2.5.2 Transmitter Mounting - Direct Pipeline Connection
The transmitter may be directly mounted into a pipe or duct as shown in Figure 13.
Caution: Do not mount the transmitter too close to the bottom
of a bend where any condensate in the pipeline might collect
and saturate the probe.
The pipe or duct will require a thread to match the transmitter body thread. Mounting
dimensions are shown in
Figure 13. For circular pipework, to insure the integrity of
a gas tight seal, a mounting flange will be required on the pipe or tubing in order to
provide a flat surface to seal against.
The following procedure must be carried out by competent
personnel.
1. Insure that the protective cover (and its desiccant capsule) has
been removed from the tip of the transmitter.
WARNING: Under no circumstances should the sensor guard
be handled with the fingers.
2. G 1/2” and 5/8” Versions - Insure that the bonded seal (2) is over the
threaded part of the transmitter body.
3/4” Version - Insure the O-ring is fully seated in the recess.
3. Screw the transmitter (3) into the pipe (1). Tighten enough to obtain a
gas tight seal. NOTE: Do not overtighten or the thread on the pipe
or tubing may be stripped.
14 15
16 17
18 18
20 21
22 23
2
3
4
5
6
7
8
9 10
11
(1.9”)
1
1
2
2
3
3
Optional
display
(available
on request)
Optional
cable
(available
on request)


48mm
Fig 03.13 (PP 24)
Figure 13 Transmitter Mounting - Pipe or Duct