KAESER KOMPRESSOREN EPC 150-2-G, Сборка и руководство по эксплуатации

Страница: 74 / 100

10.2 Following the maintenance plan
10.2.1 Logging maintenance work
The maintenance intervals given are those recommended for KAESER original components
with average operating conditions.
➤ In adverse conditions, perform maintenance work at shorter intervals.
Adverse conditions are, e.g.:
■ high temperatures
■ much dust
■ low load
Adjust the maintenance intervals with regard to local installation and operating conditions.
➤ Document all maintenance and service work.
This enables the frequency of individual maintenance tasks and deviations from our recom‐
mendations to be determined.
Further information A list is given in chapter 10.15.
10.2.2 Regular maintenance tasks
The table below lists the required maintenance tasks.
➤ Carry out maintenance tasks punctually taking ambient and operating conditions into consider‐
ation.
Interval Maintenance task See chapter
Daily or every 24 operat‐
ing hours
Check the oil level.
1)
10.8
Every 500 h Carry out air filter maintenance 10.4 / 10.5 / 10.6
Annually Check that all electrical connections are tight. –
Check the pressure relief valve. 10.11
Clean the solenoid valve 10.13.1
Every 3000 h or every 2
years at the latest
Replacing the solenoid valve. 10.13.2
Variable,
see table 36
Replace the compressor oil. 10.10
h = operating hours
1) not required for option C5
Tab. 35 Regular maintenance tasks
Further information See chapter 2.2 for information on the option codes.
10.2.3 Compressor oil Change interval
Duty cycles and ambient conditions are important factors influencing the number and length of the
oil change intervals.
10 Maintenance
10.2 Following the maintenance plan
64
Assembly and operating manual 2-stage piston compressor
EPC-2-G
No.: 9_5753 24 E