Kaden Owners Manual |
15
Issue
Possible Causes
Possible Causes
The unit is not
working
Power failure
Wait for the power to be restored
The power is turned off
Turn on the power
The fuse is burned out
Contact a qualified service technician
Remote control batteries are dead
Replace batteries
The Unit’s 3-minute protection has
been activated
Wait three minutes after restarting the unit
Timer is activated
Turn timer off
The unit starts and
stops frequently
There’s too much or too little refrigerant in
the system
Contact a qualified service technician
Incompressible gas or moisture has entered
the system.
Contact a qualified service technician
The compressor is broken
Contact a qualified service technician
The voltage is too high or too low
Contact a qualified service technician
Poor heating
performance
The outdoor temperature is extremely low
Use other heating device
Cold air is entering through doors and windows
Make sure that all doors and windows
are closed during use
Low refrigerant due to leak
Contact a qualified service technician
Indicator lamps
continue flashing
Error code appears
in the window
display of indoor
unit:
• E0, E1, E2…
• P1, P2, P3…
• F1, F2, F3…
The unit may stop operation or continue to run safely.If the indicator lamps continue to
flash or error codes appear, wait for about 10 minutes. The problem may resolve itself.
If not, disconnect the power, then connect it again. Turn the unit on.
If the problem persists, disconnect the power and contact a qualified service technician.
Note
If your problem persists after performing the checks and diagnostics above, turn off your unit immediately and
contact Customer Care 1800 080 055.
J3499_Kaden_Owners Manual_240817_V3.indd 15
28/08/2017 8:59 AM
