Kaden KDI42, Руководство по установке, Страница: 16 / 40

16 | Kaden Installation Manual
5. Outdoor unit installation
Outdoor unit installation
instructions
Step 1: Select installation location
The outdoor unit should be installed in the location that meets
the following requirements:
✓ Place the outdoor unit as close to the indoor unit
as possible.
✓ Ensure that there is enough room for installation
and maintenance.
✓ The air inlet and outlet must not be obstructed or exposed
to strong wind.
✓ Ensure the location of the unit will not be subject to
snowdrifts, accumulation of leaves or other seasonal debris.
If possible, provide an awning for the unit.
✓ Ensure the awning does not obstruct airflow.
✓ The installation area must be dry and well ventilated.
✓ There must be enough room to install the connecting pipes
and cables and to access them for maintenance.
✓ The support is flat and horizontal and can stand the weight
of the outdoor unit, and will not add additional noise
or vibration.
✓ It is easy to install the connecting pipes or cables.
✓ Determine the air outlet direction where the discharged air
is not blocked. If necessary, install a blind that does not
interfere with the air flow.
✓ The area must be free of combustible gases and chemicals.
✓ The pipe length between the outdoor and indoor unit may
not exceed the maximum allowable pipe length.
✓ If possible, do not install the unit where it is exposed to
direct sunlight.
NOTE: All the pictures in this manual are for explanation
purpose only. They may be slightly different from the air
conditioner you purchased. The actual shape shall prevail.
Fig. 5.1
✓ If possible, make sure the unit is located far away from your
neighbours’ property so that the noise from the unit will not
disturb them.
✓ If the location is exposed to strong winds (for example:
near a seaside), the unit must be placed against the wall
to shelter it from the wind. If necessary, use an awning.
(See Fig. 5.1 and Fig. 5.2)
✓
Install the indoor and outdoor units, cables and wires at
least 1 metre from televisions or radios to prevent static or
image distortion. Depending on the radio waves, a 1 metre
distance may not be enough to eliminate all interference.
✓ During heating mode, condensate should be well drained
away by the drain hole to an appropriate place, so as not to
interfere with other people.
Fig. 5.2
Step 2: Install outdoor unit
Fix the outdoor unit with anchor bolts (M10).
CAUTION
Fig. 5.3
• Be sure to remove any obstacles that may block
air circulation.
• Make sure you refer to length specifications to ensure
there is enough room for installation and maintenance.
Strong
wind
Strong
wind
Strong
wind
>60cm
Fix with bolts