S a f e t y
Page 6
Installation Instructions blueplanet XP10U H4 / H6 and XP10U H4 / H6 PSD
2 Safety
DANGER
Lethal voltages are still present in the terminals and leads of the inverter even after the inverter
has been switched off and disconnected. Lethal voltages are still present from the PV array, and
PV System Disconnect’s touch safe fuse holders.
With the PDS disconnected from both AC and DC sources, the inverter terminals are open, and can
be removed and replaced with no voltage present.
Severe injuries or death may result if the leads and/or terminals in the inverter are touched when voltage
is present.
Only authorised electricians who are approved by the supply grid operator may open, install and main-
tain the inverter.
›
Keep the inverter closed when the unit is in operation.
›
Do not touch the leads and/or terminals when switching the unit on and off .
›
Do not make any modifi cations to the inverter.
The electrician is responsible for observing all existing standards and regulations.
•
Keep unauthorized persons away from the inverter and PV system.
•
Complete all electrical installations in accordance with local electrical codes and the National Electrical Code (NEC),
ANSI/NFPA 70.
•
Ensure operational safety by providing proper grounding, conductor dimensioning and appropriate protection against
short circuiting.
•
Observe the safety instructions on the inverter and in these operating instructions.
•
Switch off all voltage sources and secure them against being inadvertently switched back on before performing visual
inspections and maintenance.
•
When taking measurements while the inverter is live:
–
Do not touch the electrical connections.
–
Remove all jewelry from your wrists and fi ngers. Remove or fasten all jewelry around your neck.
–
Ensure that the testing equipment is in safe operating condition.
•
Stand on an insulated surface when working on the inverter while it is switched on.
•
Modifi cations to the surroundings of the inverter must comply with the applicable national and local standards.
2.1 Intended
use
The XP10U converts clean renewable DC energy into AC energy for export (feed-in) into the utility.
The XP10U-H4 was designed, tested, and listed to the UL 1741, CSA-C22.2 No. 107.1.01 and the NFPA 70.
The XP10U-H6 was designed, tested, and listed to the CSA-C22.2 No. 107.1.01 and the NFPA 70.
WARNING
Potential danger
Only authorized personnel who are qualifi ed for the VAC and VDC voltage ratings should install or
maintain this equipment. Lethal hazards exist which may result in serious injury.
Operate the inverter only with a permanent connection to the public power grid.
Any other or additional use is not considered the intended use. This includes but is not limited to:
•
Mobile use
•
Use in rooms where there is a risk of explosion
•
Use in rooms where the humidity is higher than 95%
•
Operation outside of the specifi cation published by the manufacturer
•
Standalone operation.
