Kabuto FLAIR, Инструкция по эксплуатации

Страница: 20 / 25

20
Detach/ Attach adjuster
Follow the same procedure below, to exchange the
adjuster from factory attached XF-7 to the
packaged SLW-1.
Detach:
Hold the bottom of Adjuster mounting part and
slide to the fourth bigger hole as indicated in Fig.3.
Then hold the base of the arm mounting part
securely and pull gently. By doing so with the both
arms, the Adjuster will be removed.
Attach:
Push the pins at the both edges of the arm into
the basket holes. Then place the fourth hole over
the mounting projection at the rear, and slide into
it by pushing (Fig. 4.) After attaching, make sure
the chinstraps are placed in the position as
indicated in Fig. 5.
Durability of SLW-1 Adjuster
FLAIR has ultra light weight SLW-1 adjuster
packaged which is lighter than XF-7 adjuster.
SLW-1 Adjuster is ultra light, intended to be
used at special occasion such as racing. As
such, it is designed to simplify its adjustment
function and enhance its durability by cutting
down its weight to the limit. Please be aware
the adjuster durability may deteriorate
significantly by frequency, application, and
condition of usage.
Fig. 3
Fig. 4
Chinstrap
Fig. 5
XF-7
Adjuster
(Replacement) XF-7 Adjuster and SLW-1 Adjuster
XF-7 Adjuster and SLW-1 Adjuster are available as replacement parts.
This procedure is
for XF-7 adjuster only
Move the
mounting hole to
the fourth hole
position and
twist a little.
Move the
mounting hole to
the fourth hole
position and
twist a little.
Mounting part
bump
Place the
thumb under
the part
and lift the
Adjuster a
little.
Mounting part
bump
Place the
thumb under
the part
and lift the
Adjuster a
little.
Let the chinstrap
go through the
XF-7 adjuster as
illustrated.
Kabuto’s helmet adjusters are developed exclusively to each models.
Please confirm the model at purchasing the replacement.
CAUTION!
Please refer to Parts List on our website for more information about
replacement.
http://www.ogkkabuto.com/