Kaba E-PLEX 2000, Руководство по эксплуатации

Страница: 18 / 32

16
H-5 Enter the code 1224# again.
H-6 Example of Complete Entry: 101#024#1224#1224# .
H-7 Enter another # to indicate the end of programming.
H-8 The Manager Access Code 1224 will now work in that door with all the
access privileges assigned to a Manager User.
H-9 Manager Users can open the door by just entering the Access Code
without the # signs, or put the lock into Pushbutton Programming Mode
by entering # before and after their Access Code.
I. ADD/MODIFY SERVICE USER ACCESS CODE
A Service User is any person who needs access to the lock for a limited time
period in order to perform a service, such as painting or repairs in the room or
area. A Service User Access Code allows the service person to enter, exit and
re-enter using that code for a certain number of hours.
Required User Level: Master, Manager
I-1 Put the lock into Pushbutton Programming Mode.
I-2 Enter Command 102# to add / modify a Service User Access Code.
I-3 Enter the Service User ID location (a three-digit number you have on a list
that you should carry with you) followed by #, for example 025# .
I-4 Enter UUUUUUUU# , representing a User Access Code of between 4 and
8 numbers depending on the length of Access Code that you selected in
Procedure 1 on page 7. For example, if your code length is 4 digits, it could
be 2240# .
I-5 Enter the code 2240# again.
I-6 Now enter the number of hours, programmable between 01 and 24, for
example 06 . If you enter a Service Access Code of 00, you can only enter
the door once. If the door shuts upon exiting, you will not be able to re-
enter. This type of access is called a “one-shot” code.
I-7 Example of Complete Entry: 102#025#2240#2240#06# .
I-8 Enter another # to indicate the end of programming.
I-9 The Service User Access Code 2240 will now work in that door, with all
the access privileges assigned to a Service User for a period of 6 hours
from the time the Service User enters his Access Code.