11
F-7
For Right-Handed Levers: Turn the key
approximately 90
º
clockwise so that it is in the
vertical position and the countersink (g) is in
the top position.
For Left-Handed Levers: Turn the key approx-
imately 90
º
clockwise so that it is in the verti-
cal position and the countersink (g) is in the
bottom position.
F-8
Fit the lever handle (h) onto the drive
tube. It should rest approximately
1
⁄
16
"
(2 mm) from the body of the housing.
If it can’t be pushed that close to the
housing, the lever catch (f) is probably
not pushed in. Push it in.
If the lever catch (f) is stuck, the over-
ride shaft is in the wrong position. The
two small indents on the cross of the
override shaft must be vertically
aligned.
F-9
Press the lever firmly against the
housing while turning the key counter-
clockwise (this applies to both Right-
Handed and Left-Handed locks) until it
is in the horizontal position.
Important: If it is not possible to turn
the key counter-clockwise to complete
this step, the spring washer (d) may
be too tense:
Tap the lever carefully with a rubber
mallet to loosen the spring washer (d).
Cover the lever handle with a cloth or
other material to protect the finish of
the metal.
Right-Handed
lock
Countersink (g)
in TOP Position
Countersink (g) in BOTTOM Position
Left-Handed
lock
Right-Handed
lock
Left-Handed
lock
F-2
Turn the override shaft 90
º
clockwise so
that the two small indents on the cross
are now vertically in line. (The cylinder
can be used to turn override shaft.)
F-3
Push in the lever catch firmly.
F-4
Insert the cylinder (j) into the lever handle (h).
F-5
Put the cylinder plug (k) into the lever (h).
F-6
Making sure that the cylinder plug (k) does
not fall out, insert the key into the cylinder
(j). The key will be horizontal.
Caution: The position of the key is very important. If the lever is not assembled
with the key in the correct position before placing the lever on the housing, the
inside mechanism of the lock could be damaged if the lever is rotated and
forced.
10
Countersink (g) in
the top position
Countersink (g) in
the bottom position
h
h
j
j
k
f
