5
E-730/630/750/79E/RT Series Installation Guide - PK3677_T_04_16
Three AA batteries should already be installed in the
battery holder (J). Insert the battery holder into the
outside housing and secure it using the
6-32 X 3/8” spanner drive screw (K).
* For Mechanical Override Models refer to page 10 .
If the lock makes a continuous buzzing noise or the
red LED lights continuously, reset the electronics by
removing the battery holder for ten seconds, then
reinsert it.
!
Assemble the lever on the outside housing, in
the horizontal rest position appropriate to the
handing of the door as shown. Simply push the
lever onto the tube until it clicks in place . If
more force is required to engage the handle,
use a rubber mallet. Test the attachment of the
handle by pulling smartly on it.
For mortise exit devices, install the mortise according to the manufacturer’s instructions .
The lever is field reversible. If
the handing is incorrect, insert
a small pick or flat screwdriver
in the hole in the hub as shown.
Gently pry back the spring clip
inside the hub, and remove the
handle.
A
B
1
Install the Mortise (if applicable)
2
Install the Outside Lever
3
Install the Batteries
Access Hole
cutaway view
J
K
D INSTALL THE LOCK AND THE EXIT DEVICE
