13/16"
20.6
1 15/16"
49.5
2 15/32"
63.0
3 5/8"
92.1
5X 7/16"
11.1
2 1/2"
THIS DIM. IS FOR
END THROW BOLT
ONLY
63.5
1 1/2"
THIS DIM. IS FOR
CROSS THROW BOLT
ONLY
38.1
1- Position the bolt edge of the template
on the bolt edge of the door.
2 - Move the template along the
the bolt edge of the door
to the desired position.
3 - Tape in place.
1 - Center punch the five lock mounting holes.
2 - Drill all holes with the 7/16" [11mm] drill bit.
(If a step drill is not used, a pilot hole may be required)
3 - Deburr all holes using a file or deburring tool.
PREPARING THE DOOR
FOR LOCK MOUNTING
PLACING TEMPLATE
ON DOOR
A
B
C
TEMPLATE FOR INSTALLATION OF THE
UNICON DEAD BOLT LOCK
ON A METAL DOOR
TOOLS REQUIRED
PREPARING DOOR FOR
BOLT GUIDE
FRONT FACE OF DOOR
END THROW BOLT
CROSS THROW BOLT
(ONLY CROSS THROW POSITION ALLOWED)
1- Mark the three holes using the
dimensions shown on the left
side of this sheet.
2 - Drill the two small holes with a
1/8" [3mm] drill.
3 - Drill the center hole with a
5/16" [8mm] drill bit. (Bolt must
slide freely in this hole.)
4 - Deburr all holes.
CROSS THROW
DOOR EDGE
END THROW DOOR EDGE
1/4" MIN
1/2 " MAX
6.5
3/8"
9.5
3/8"
9.5
2X 1/8"
[3mm]
5/16"
[8mm]
