5
8.
Tape the flex cable to the outside of the tube with the insulator tape
provided in the installation kit.
9.
While holding the lock case assembly, again carefully guide the end of the
flex cable and the tube through the inside of the container so that they are
easily accessible at the outside of the container.
10. Mount the lock case assembly to the inside of the container door in the
proper orientation using the four lock case mounting screws for a Battery
lock or three screws for Non-Battery lock.
Note:
It is recommended that you use Loctite
®
262 (Red) on the lock case
mounting screws.
11.
For Spring Bolt Model:
Insert the end of the spindle with the
screw hole into the lock case assem-
bly until the spindle is properly
seated.
For Dead Bolt Model:
Remove the spring from the spindle
and insert the spring end of the
spindle through the spindle hole on
the container and into the spindle hole
on the lock case (Figure 5). Make
sure that you insert the spindle far
enough into the spindle hole so that it
engages with the cam.
12. The grooved side of the spindle
should be oriented so that the
grooves in the spindle align with the
grooves in the drive cam. Turn the
spindle so that the grooves in the
spindle are facing toward the ex-
tended bolt, if they are not already
oriented in that direction.
13. Mark the spindle shaft 3/16” from the
container door for cutting (minus 1/32”
allowed.) (Figure 6)
14. Remove the spindle from the lock
case to prevent damage to the cable
while cutting.
15. Use the hacksaw to cut the spindle
on the mark.
16. Use a small, flat file to deburr the spindle after cutting.
17. If you are installing a Dead Bolt version of the lock, place the spring back
onto the spring end of the spindle.
Figure 6 - Mark spindle for cutting
Figure 5 - Insert spring end of spindle
into spindle hole
Содержание Low Profile 52 series
Страница 1: ...INSTALLATION GUIDE LOW PROFILE LOCK ...
Страница 14: ...12 ...
Страница 15: ...NOTES ...