K2 Mounts K2 Series, Руководство пользователя

Страница: 5 / 16

4 www.k2mounts.com www.k2mounts.com 5
Attach the Mounting Plate to a Wood Stud Wall
If you are mounting to a concrete or concrete block wall, skip this section and go to “ Attach the
Mounting Plate to a Concrete or Concrete Block Wall ” on page 7.
Locate the Wall Studs
Wall studs run vertically (up and down) inside the wall, behind the drywall or plaster. You
must attach the Mounting Plate to two separate wall studs.
1. Using the stud finder, make a mark at the left and right edges of the two closest studs on
each side of the Mounted screen Center Point.
2. Mark the centerline of each stud by holding the level vertically, and drawing a line halfway
between the left and right edges of each stud.
These stud centerlines should be vertical, and roughly parallel. If they are not, the studs may
not run continuously from floor to ceiling and you must not use them to hang the screen.
Locate different studs that run
continuously from floor to
ceiling.
The K2 series mounts require
the wall studs to be 16 inches
apart (16 inches on center).
These mounts cannot be used if
the wall studs are spaced farther
apart.
2" x 4" 2" x 4"