K2 Mounts K2 Series, Руководство пользователя

Страница: 6 / 16

6 www.k2mounts.com www.k2mounts.com 7
Determine Mounting Hole Locations
1. Using the level and measuring tape, make a mark 2
7/8” directly above and 2 7/8” directly below the
Mounted screen Center Point. These marks are the
Upper and Lower Center Points.
2. Using the level, draw a horizontal (side-to-side) line
through the Upper Center Point that connects all
stud centerlines. Draw a similar line through the
Lower Center Point.
The intersection of the horizontal lines with the stud
centerlines are the Mounting Hole Locations. Using the
drill and 3/16 inch drill bit, drill pilot holes 2-1/2 inches
deep into the stud at each intersection point.
Anchor Mounting Plate to the Wall
1. Hold the Mounting Plate against the wall.
Aligning the center of the Mounting Plate with
the Mounted screen Center Point, move the
Mounting Plate so that the pilot holes are visible
through the slots.
2. Using the ratchet and 7/16 inch socket, anchor
each Mounting Plate into the wall with six 1⁄4” x
2-1/2” Lag Bolts and Mounting Plate Washers.
!
Warning: On each Mounting Plate, you must fasten all six Lag Bolts
securely into wall studs for proper installation. Failure to do so could result
in property damage or personal injury.
3. Go to “ Attach the Screen Arms to the Screen ” on page 9.
Mounting Hole Locations