3
Figure 1 - Model KTI63504 Series A Components
Before Use
1.
Verify that the product and application are compatible, if in doubt call KTI Technical Service.
2. Before using this product, read the operator's manual completely and familiarize yourself thoroughly with the
product, its components and recognize the hazards associated with its use.
3. Press the release valve pedal, ensure that saddle is fully lowered. Remove shipping screw and
replace with
provided
vent screw
(shipping screw is located above the oil filler screw)
.
4. Remove the oil filler screw. Ensure oil level is just below the rim of oil filler hole. Reinstall the oil filler screw.
5. For air option model KTI63504 Series A, pour a teaspoon of good quality, air tool lubricant into the air supply inlet
of the lift control valve. Connect to air supply and operate for 3 seconds to evenly distribute lubricant.
note:
This unit is equipped with the popular 1/4” NPT air coupler. When installing a different air coupler of your
choice, ensure that thread tape or compound is used when servicing connections. To ensure dependable, trouble
free operation an inline air dryer and oiler is recommended.
6. Ensure that jack rolls freely. Raise and lower the unloaded jack throughout the lifting range before putting into
service to ensure the pump operates smoothly. Replace worn or damaged parts and assemblies with factory
authorized replacement parts only.
Saddle Plate
Saddle Socket
Tilt Adjustment Knobs
Position Handle
Hydraulic Unit
Lift Pedal
Release Valve Pedal
Base Half
Caster
Oil Filler Screw
Shipping Screw
(replace w/ Vent Screw
before initial use)
Ratchet Bracket
*Air Motor
*Air Supply Inlet
*Air Pump Pedal
(*) For air option model KTI63504 Series A only
