2
SaFetY and GeneraL inFOrMatiOn
Save these instructions.
For your safety, read, understand, and follow the information provided with and on this jack
before using. The owner and operator of this equipment shall have an understanding of this jack and safe operating
procedures before attempting to use. The owner and operator shall be aware that use and repair of this product
may require special skills and knowledge. Instructions and safety information shall be conveyed in the operator's
native language before use of this jack is authorized. If any doubt exists as to the safe and proper use of this jack,
remove from service immediately.
inspect before each use.
Do not use if broken, bent, cracked or damaged parts are noted. Any jack that appears
damaged in any way, or operates abnormally shall be removed from service immediately. If the jack has been or
suspected to have been subjected to a shock load (a load dropped suddenly, unexpectedly upon it), immediately
discontinue use until jack has been checked by a factory authorized service center (contact distributor or manufacturer
for list of authorized service centers). It is recommended that an annual inspection be done by qualified personnel.
Labels and Operator's Manuals are available from manufacturer.
PrOdUct deScriPtiOn
This Transmission Jack is designed to be used as an aid in the removal and installation of automotive and light truck
transmissions, transfer cases and transaxles. This telescopic style transmission jack is for use under an overhead
lift or in a garage pit. On air option model KTI63504 Series A, ensure that your air source can dedicate 7.8 CFM @
110-175 psi to each jack operated.
NEVER
use for any purpose other than those uses outlined above!
!
SPeciFicatiOnS
Model
Capacity
Min. Height Max. Height
Saddle Base
Extended Saddle
Area
Jack Size
KTI63503
Series A
1000 Lbs
37-3/4"
78-1/8"
8-7/8" x 7-1/8"
21" x 21"
33-5/8" x 33-5/8"
KTI63504
Series A
PreParatiOn
assembly
(refer to Figure 1)
Tools required: 1/4" allen key, 19mm wrench, 3/8" hex socket & torque wrench.
1. Three major parts should be included in the package:
(a) Hydraulic unit Assembly;
(b) Saddle Assembly;
(c) 2 pieces of base half with hardware.
2. Attach either one of the two base halves to the base of the hydraulic unit, then secure using allen head bolts and
washers provided. Apply the same procedure to the other base half. Use torque wrench to tighten to 30 lb.ft. Do
not overtighten.
3. Place the socket of the saddle assembly onto the ram piston. Tighten set screw on the socket.
