5
Image 3
Image 4
3. Repeat step 2 for the rolling stand. The wheels
of the rolling stand assembly are designed to
ride on the rails of the track to keep the stand
and tractor straight. Position the rolling stand as
close as possible to the point where the tractor
will be split, except on the opposite side of the
split point from the stationary stand.
(Image 3)
NOTE:
There are bolts in the side of the track
sections. These are to be used as stops for the rolling
stand. DO NOT remove these stops and allow the
rolling stand to roll off from the track.
4.
Raise the jacks on both stands, by turning the
screw using the crank handles, until they make
contact with the underside of the tractor. If
available, bolt the stands/spacers to the bottom
of the tractor.
(Image 4)
WARNING:
A
LWAYS
INCREASE
THE
HEIGHT
OF
THE
STAND
AS
MUCH
AS
POSSIBLE
BY
ADDING
SPAC
-
ERS
FIRST
. NEVER
USE
MORE
THAN
THREE
(3)
SPACERS
PER
STAND
ASSEMBLY
(
TWO
(2)
TALL
SPACERS
AND
ONE
(1)
SHORT
SPACER
PER
STAND
).
WARNING:
T
HE
SPACERS
AND
STAND
ASSEMBLY
MUST
BE
SECURED
TOGETHER
USING
THE
PRO
-
VIDED
HARDWARE
.
WARNING: W
HENEVER
POSSIBLE
,
THE
STANDS
/
SPACERS
MUST
BE
BOLTED
TO
THE
TRACTOR
FOR
STABILITY
.
U
SE
HIGH
GRADE
BOLTS
(G
RADE
8 R
ECOMMENDED
)
AND
HARDENED
WASHERS
.
WARNING: DO NOT
LIFT
THE
TRACTOR
USING
THIS
SYSTEM
. T
HIS
SYSTEM
IS
DESIGNED
TO
SUPPORT
THE
TRACTOR
DURING
SPLITTING
,
NOT
TO
LIFT
THE
TRACTOR
.
5.
Refer to the tractor service manual and proceed
with splitting the tractor. The rolling stand will
let you move the two sections of the tractor
apart and back together again when service is
complete. Always use extreme caution when
splitting a tractor and rolling the sections of
tractor apart.
6.
When the tractor is reassembled following the
tractor service manual and service is complete,
the splitting stands can be removed. Lower the
stands and disassemble the splitting stands by
reversing these instructions.
Содержание AT30000
Страница 7: ...7 NOTES...
