Jydepejsen Athene, Инструкция по установке и эксплуатации

Страница: 20 / 28

Replacing door gaskets (except the Cubic series)
1. Remove the gasket from the inner frame and clean the band mark (it is not nec -
essary to remove the door from the stove).
2. Add a band of heat-resistant glue on the band mark.
3. Push new gasket down into the mark.
4. Close the door and let the glue harden for about 24 hours, before you open the
door again. If you do not let the glue harden sufficiently before you open the
door, the gasket may fall out.
Replacing the gasket at the glass (except the Cubic series)
1. Lift the door from the hinges and place it on a flat base.
2. Dismount bolts / screws from the inner frame.
3. Dismount the bolt and the ratchet that hold the handle.
4. Lift off the inner frame.
5. Remove the old gasket from the glass.
6. Add new gasket to the glass.
Remounting of the glass takes place in the opposite order.
Replacing door gaskets - Cubic series
1. Remove the gasket from the inner frame
2. Push new gasket down into the groove.
Replacing the gasket at the glass - Cubic series
1. Lift the door from the hinges and place it on a flat base.
2. Dismount bolts and screws from the closing system.
3. Dismount 2 screws at the bottom and 2 screws at the top.
4. Lift off the inner frame.
5. Remove the old gasket from the glass.
6. Add new gasket to the glass.
Remounting of the glass takes place in the opposite order.
20
Change of the vermiculite panels
1. Lift up and turn the lower baffle plate
a little, pull it down along the side
panels and out through the door.
2. Remove the two side panels in the
front.
3. Remove the two side panels in the
back.
4. Now you can remove the upper baffle
plate.