JVC XV-C5SL, Руководство по обслуживанию

Страница: 13 / 74

(No.XA001)1-13
2.2.4 Attaching the DVD pickup unit
(See Figure 3, Figure 4, Figure 5, Figure 6, Figure 7)
Reference:
Refer to the explanation of "Removing the DVD pickup unit" on
the preceding page.
(1) Attach the SW. actuator and shaft 1 to the DVD pickup unit.
(See Figure 5)
(2) Engage the section i of the DVD pickup unit to the shaft 2
of the DVD traverse mechanism assembly first, and set the
both ends of the shaft 1 of the DVD pickup unit in the sec-
tions
h and h' of the DVD traverse mechanism assembly.
(3) Slide the DVD pickup unit all the way in the direction of the
arrow.
(4) Mesh the lead screw to the section j of DVD pickup unit and
then set the end of the lead screw to the section g .
(5) Attach the thrust spring. (See Figure 4)
(6) Attach the bracket. (See Figure 3)
Fig.6
Fig.7
2.2.5 Removing the spindle motor board
(See Figure 8, Figure 9)
• Remove the DVD servo control board.
• Remove the DVD traverse mechanism assembly.
(1) From the top side of the DVD traverse mechanism assem-
bly, remove the feed motor wire that is soldered to the spin-
dle motor board.
(2) From the back side of the DVD traverse mechanism as-
sembly, remove the three screws E attaching the spindle
motor board.
Fig.8
Fig.9
Section i
Section h
Section h'
Shaft 2
Shaft 1
DVD pickup unit
DVD pickup unit
Section g
Section j
Lead screw
Spindle motor
board
Feed motor
wire
Feed motor
Remove the solders.
E
E
Spindle motor
board