9
4.
Open the cable connection cover
Use provided hexagon wrench to remove the 4 screws
(M3 x 12) from the cable connection cover to open it.
5.
Connect each cable
Connect the necessary cables.
6.
Bind cable using a waterproof tape
Upon connecting, ensure to perform waterproofing
procedures by binding the joint of each cable with a
waterproof (adhesive) tape.
7.
Fasten the cables in the interior of the arm
When waterproofing is complete, insert the cables into the
upper interior of the arm and fasten using a tape.
8.
Cover the hole and the mounting side of
housing with waterproof seal.
After the cables have been connected, cover the holes
made in step
1.
with waterproof seal. With the Cable
connection cover open, put your hand in and cover the
hole. Cover the mounting side of the housing with
waterproof seal.
9.
Close the cable connection cover
When cable connection is complete, close the cable
connection cover and fasten 4 screws (M3 x 12) removed
in step
4.
using the provided hexagon wrench.
Mounting the Housing to the Wall (continued)
4.
9.
5.
8
.
6.
7.
8
.
T
Not in use on this system.
Bind using a waterproof
(adhesive) tape
Bind with insulating tape
T
DC 12 V Power Cable
Alarm/Communication Cable
Coaxial
Video Cable
Hole
Waterproofing
Screw (M3 x 12) x 4
AC 24 V
Power Cable
LAN Cable (Male)
Waterproofing
NOTES:
●
When connecting to TK-C625U/E, ensure to bind
connectors of LAN cables that are not in use with an
insulating tape before using.
●
Ensure to bind the DC 12 V Power Cable that is not in use
on this system with insulating tape.
CAUTION:
For safety reasons, turn on the power only upon connecting
all cables.
CAUTION:
When inserting the cables, ensure that all cable connections
are above the cable connection cover (see dotted line in the
left diagram
7.
).
Failure to do so may cause malfunctions due to penetration
of rain water.
NOTE:
●
Be sure to perform waterproofing. Seepage of rainwater
may result in malfunction.
●
Use GE silicon or its equivalents as the sealing material.
WB-1540_1550.book Page 9 Thursday, May 17, 2007 3:21 PM