ENGLISH
E-29
Field angle adjustment
Loosen the fastening screw of the zoom
adjustment ring, move the ring horizontally and
adjust the image size.
Focus adjustment
Press the focus adjustment button. The Iris will
open for approximately 30 seconds. Loosen the
fastening screw of the focus adjustment ring,
move the ring horizontally and adjust the focus.
Memo :
●
Repeat
2 to 3 times and configure the
settings.
After adjustment is complete, tighten and
secure the respective fastening screws.
●
Pressing the focus adjustment button
automatically activates the electronic shutter.
The screen may flicker but this is not a
malfunction.
Brightness adjustment
Normally, adjustment is not required. If
necessary, adjust the Iris level.
Note :
●
For adjusting the brightness, do not conduct
it within 30 seconds after pressing the focus
button.
Memo :
●
When adjusting the iris level, set the AGC
function to
. Otherwise, when the level
is turned too far toward L, the AGC function
activates increasing sensitivity and the
picture may look uneven.
For
A
AGC function settings
B
, please refer to
the [INSTRUCTIONS] (pdf) in the supplied
CD-ROM.
After all settings are complete, mount the dome
cover.
1.
Mount the dome cover.
Align the camera with the position alignment
mark on the dome cover and push in the
dome cover to mount.
Note :
●
Push in the dome cover until you hear a click
sound. Check that it has been securely
mounted. Insecure mounting may cause the
camera to fall or interfere with the LED
(Status, Link, Act) display.
●
When the cover is removed again after
mounting the dome cover, adjust the field
angle.
To darken : Anti-clockwise direction (towards L)
To brighten : Clockwise direction (towards H)
Mounting the Dome Cover
1.
Position alignment
mark
VN-C215_EN.book Page 29 Tuesday, March 20, 2007 1:54 PM
