32
2-3 Setting IP Address for this Camera Using the "VN-C205U Setup Tool"
Settings (Step 2 Network Settings)
Set the IP address for VN-C205 using the "VN-C205U Setup Tool" that has been installed.
(This "VN-C205U Setup Tool" only allows connection of VN-C205.)
1.
Select [Start]
†
[Programs]
†
[V.NETWORKS]
†
[VN-C205U Setup Tool] to start
up the "VN-C205U Setup Tool".
The [V.Networks Search] screen is
displayed.
Click
to start search and
a [V.Networks IP Address List] will
appear.
• [TimeOut] is for setting the time for searching (1 to 30 seconds). If no IP address is displayed
upon searching, change the value to a longer time and search again.
• If the [V.Networks] on the LAN has a different subnet from that of the PC, connection may not
be possible even if the IP address of the camera is found via search. Change the IP address
of the PC to an appropriate value and connect the camera.
1
Enter the IP address of the camera to be
connected in [Connection IP address].
Default IP address is
192.168.0.2
.
2
Click
.
Notes
To view the IP address of the connected camera, click "Search".
Note
To connect to a VN-C205 for which DHCP has been enabled, the DHCP server must exist in an
environment where the assigned IP address and MAC address are clearly defined. If the DHCP
server is not found, it will automatically start up using the static IP address after 60 seconds.
Cautions
• Upon turning on the power of this camera, it may take about 60 seconds before it can be
connected to the PC.
• At the factory, DHCP is enabled for VN-C205.
• Using DHCP
JVC does not recommend operating VN-C205 with the DHCP function enabled because a
different IP address may be assigned upon the renewal of the leasing contract. The DHCP
function of VN-C205 is included with the aim to simplify installation/setting procedures.
33
2.
Check settings.
3.
Click
.
4.
Start up the "V.Networks Controller".
(
☞
Page 56)
For other settings,
☞
next page
Click
.
[V.Networks ID] works as an identification
code set to VN-C205. Only alphanumeric
characters can be used.
This ID does not directly affect operation
by the user.
Normally, the ID is set as CAM00001,
CAM00002, etc.
(0 to 8 characters)
1
Select whether to use DHCP.
Note
The IP address of the DHCP server
and other information can be checked
when [DHCP] is selected.
2
Change the IP address to the one assigned
to or approved by the administrator.
3
Set Subnet mask to an appropriate value.
Ask the network administrator if necessary.
Note
Upon clicking OK, VN-C205 will be
automatically reset and the set values
will be enabled.
Note
In a system where more than 1 VN-C205 is used, turn on the power for a VN-C205 first, followed
by setting the camera until "2-3 Setting IP Address for this Camera Using the 'VN-C205U Setup
Tool' " is completed. Upon doing so, turn on a second camera and perform setting in the same
way. Perform the same procedure for subsequent cameras.
4
Click
.
