27
English
Timer Operations
• When you unplug the AC power cord or if a power failure
occurs, the timer will be canceled. You need to set the clock
first, then the timer again.
• Without Stopping the recording, you cannot change the source
after Recording Timer starts recording.
• You cannot use the SLEEP timer while activating the
Recording timer.
• If you set the Sleep Timer after Daily Timer starts playing the
selected source, Daily Timer is canceled.
Other
The following settings are memorized by the system for two or
three days even if the AC power cord is removed. The settings
are reset to factory default values after few days in which case
you must set them again.
Preset stations, volume, BASS/TREBLE, AHB PRO,
SOUND TURBO, AUX LEVEL, QP Link, and timer.
To remove the speaker grilles
Troubleshooting
If you are having a problem with your System, check this list
for a possible solution before calling for service.
General:
Adjustments or settings are suddenly canceled before
you finish.
]
There is a time limit. Repeat the procedure again.
Operations are disabled.
]
The built-in microprocessor may malfunction due to
external electrical interference.
Unplug the AC power cord
and then plug it back in.
Unable to operate the System from the remote control.
]
The path between the remote control and the remote sensor
on the System is blocked.
]
Point it at the remote sensor on the front panel.
]
Signals cannot reach the remote sensor.
Move closer to the System.
]
The batteries are exhausted.
No sound is heard from the speakers.
]
Speaker connections are incorrect or loose (see page 7).
]
Headphones are connected (see page 9).
System does not turn off.
]
QP Link is active (see page 14).
Radio Operations:
Hard to listen to broadcasts because of noise (see pages 4
to 6).
]
Antennas connections are incorrect or loose.
]
The AM loop antenna is too close to the System.
]
The FM antenna is not properly extended and positioned.
Disc Operations:
The disc does not play.
]
The disc is placed upside down. Place the disc with the label
side up.
The disc sound is discontinuous.
]
The disc is scratched or dirty.
The disc tray does not open or close.
]
The AC power cord is not plugged in.
]
Child Lock is in use (see page 20).
Tape Operations:
The cassette holder cannot be opened.
]
Power supply from the AC power cord has been cut off
while the tape was running. Turn on the System.
Impossible to record.
]
Small tabs on the back of the cassette are removed.
Cover the holes with adhesive tape (see page 22).
Timer Operations:
Daily Timer does not work.
]
The System has been turned on when the on-time comes.
Timer starts working only when the System is turned off.
Speaker
grille
Holes
Projections
UX-G45[UW].BOOK Page 27 Tuesday, May 30, 2006 2:07 AM
