No. 51922
TM-H1700G
18
3.
HOW TO OPERATE EACH SERVICE MENU ITEMS
■
SIGNAL BLOCK
①
In the <BLOCK SELECT> screen, press the
CHROMA/PHASE
key.
②
Then SIGNAL BLOCK adjustment mode screen is displayed (Fig. 7).
③
The original front key function replaced with the different function
displayed at the lower side of the screen as shown below.
Refer to the illustration given below, the function about each key in
this mode.
④
In this mode,
UNDER SCAN
key is the switch of the screen display. If
necessary, you can shut off the display. Carefully, values of
adjustment items are changed while shut off the screen display.
⑤
Press the
MENU
key, then exit the SIGNAL BLOCK screen to return
to the <BLOCK SELECT> screen.
■
WHITE BALANCE BLOCK
①
In the <BLOCK SELECT> screen, press the
CONTRAST/BRIGHT
key.
②
Then WHITE BALANCE menu screen is displayed (Fig. 8).
③
In this case, key function is replaced as shown below. There are
several modes of WHITE BALANCE adjustment. Select the various
WHITE BALANCE mode from this menu screen.
④
Press the
MENU
key few times, then exit from the WHITE BALANCE
BLOCK screen to return to the <BLOCK SELECT> screen.
* * *
* * *
* * *
* * *
< S01 > :
EXIT DISP
SIGNAL BLOCK
* * *
* * *
* * *
* * *
< S01 > :
EXIT DISP
Fig. 7
< Function Display >
Service number indicated
Setting value indicated
< Front Panel Key Arrangement >
Select the Service Number
Data operate (inc/dec) key
Adjustment mode exit key
Display on/off switch
CUT O
W01
EXIT
65-D
93-D
WHITE BALANCE BLOCK
<ITEM SELECT>
CUT OFF : CUTO
6500 DRIVE : 65-D
9300 DRIVE : 93-D
CUT O
W01
EXIT
65-D 93-D
Fig.8
<Function display>
<Front Panel Key Arrangement>
Select the CUTOFF mode
Select the 6500 DRIVE mode
Select the 9300 DRIVE mode
Select the various item nodes
Adjustment mode exit key
