JVC TK-C400E Скачать руководство пользователя страница 52

Страница: 52 / 52

4-14

VICTOR COMPANY OF JAPAN, LIMITED

LENS ADJUSTMENT

Video adjust

Connect the camera according to the connection method, turn it on, display an image on the
monitor, and check the image. The camera has been factory-adjusted to the best position, but it
may need to be adjusted according to the object conditions or combination of lenses. If the image
is unnatural, adjust it as follows:

• LEVEL adjustment

• ALC adjustment

• If the sensitivity adjustment LEVEL is turned excessively to L, the sensitivity increases be-

cause of the AGC function of the camera, and the image looks grainy.

• If the video iris lens is set to too low a level, malfunction such as the hunting phenomenon, in

which the iris opens or closes unintentionally, may occur.
In such a case, first set LEVEL potentiometer on the lens to the H (iris open) position then
adjust it to the optimum level.

Back focus adjustment

The back focus has been factory-adjusted to the best point for CS-mount lens, but it
may need to be re-adjusted if the mount is changed to the C-mount or if a different lens
is used. If required, adjust it as follows:

• With a fixed-focus lens

If the focus can not be adjusted correctly by rotating the lens focus ring, adjust the back focus as
follows.
1. Loosen the back focus locking screw by turning it counterclocckwise (

) with a screwdriver.

2. Turn the back focus adjustment ring to focus at the best point.
3. Tighten the back focus locking screw by turning it clockwise (

• With a zoom lens

If the image is out of focus when zooming (wide-angle telephoto), adjust the camera as follows:
1. Shoot a comparatively dark scene with thin lines about three meters away from the camera.
2. Set the lens to the maximum telephoto position, and adjust the lens focus.
3. Set the lens to the maximum wide-angle position, and adjust the focus.
4. Repeat steps 2 and 3 two or three times.

SETTING SWITCH

Line Lock

To set the camera in LL mode for synchronization with the power supply frequency, take the follow-
ing steps:
1. Turn switch

to “LL”;

2. Turn switch

to “PHASE”;

3. Press the + or – button

to make the phase variable.

Adjust with the button

so that the vertical phase of the camera matches the vertical phase of

another camera (or system) with a multi-channel oscilloscope.
For initial setting, press RESET button

U type: 60Hz power region only
E/EG type: 50Hz power region only

White Balance

White balance can be adjusted within the scope of 2900 - 8000K color temperature. When switch

is at “AUTO”, the white balance is adjusted automatically.

For manual adjustment, take the following steps:
1. Turn switch

to “MANUAL”;

2. Turn switch

to “W.B.”;

3. Pressing “R” button

increases redness while pressing “B” increases blueness. For initial

setting, press RESET button

BLC (Back Light Compensation)

The switch

improves an image that is darkened because of backlighting.

Set this switch to ON for backlight subjects.

AES (Automatic Electronic Shutter)

Turning this switch

"ON" when a lens with a manual iris diaphragm is used enables the auto-

matic adjustment of image brightness. In this case the shutter speed changes according to the
brightness of the subject. AES functions only when AGC switch

is turned on.

Hunting may occur at a certain object brightness due to the mechanism of the AES circuit, but
this is not a fault.

AGC (Automatic Gain Control)

The switch

automatically increases the camera’s sensitivity when the level of ambient light

drops.
ON: AGC is activated.
OFF: AGC is not activated.

For Service

Interface Connector

is used for service.

SPECIFICATIONS

Image pickup device

: 1/3-inch interline-transfer CCD