9
EVA
foam
Z
ithout
K
oles
backing paper
EVA foam
(with holes)
included
Bracket
width
2CM
0.75 IN
Follow below steps to mount the sound bar on the wall
Step 1: Paste 2 pieces of EVA foam (with holes) on the two wall brackets aligning at the hole position of
wall brackets.
Step 2: Remove 4 screws from the rear housing of sound bar, then insert the 4 screws over the wall bracket
screw holes aligning (on the side of EVA foam pasted), and then fasten the screws again.
Step 3: According to the two hanging wall positions on the rear of soundbar, calibrate and mark the two
hanging brackets hole position on the wall. Then drill two holes on the wall, firstly insert two
expansion plastic screws on the wall, then fasten the hanging screws into expansion screw holes.
Step 4: Then Paste the 2 pieces of EVA foam (without holes) on the two wall brackets downward. Then
place the hollow cross in the center of the bracket against the screws on the wall and hang the
sound bar on the wall finally.
Table Placement
•
Place the sound bar horizontally on a solid surface such as a TV
unit or shelves and align it centrally with the TV screen.
•
For best sound output and good airflow around the soundbar,
place your soundbar as shown on the right.
6UYOZOUTOTM ZNK 9U[TJ (GX
Wipe off any dirt such as oil on the adhesive surface of the sound bar before adhering.
Make sure that the adhesive is securely attached.
When peeling off the release paper of the double-sided tape, be careful not to get dirt such as finger oil
on the adhesive surface.
Be careful of deterioration of double-sided tape due to storage conditions.
Please note
