41
English
4. Press TEST to start checking the speaker output balance.
“TEST TONE L” starts flashing on the display, and a test
tone comes out of the speakers in the following order:
IMPORTANT:
• Output the test tone while playing back an audio source.
With the DVD digital input selected as the source, no test tone may come out while
no signal is input to this receiver.
• Test tone comes out even while playing back a source encoded with Dolby Digital. In
this case, the PRO LOGIC indicator lights up on the display.
5. Adjust the speaker output levels as follows:
• To adjust the center speaker level, press CNTR +/–.
• To adjust the left rear speaker level, press REAR•L +/–.
• To adjust the right rear speaker level, press REAR•R +/–.
6. Press TEST again to stop the test tone.
7. Press CNTR TONE to select the center tone level you want.
The center tone adjustment affects the mid-frequency
range, which the human voice is mostly made up of.
Each time you press the button, the display changes to
show the following:
Adjusted levels are also shown on the equalizer display.
To make the dialogue clearer, select “SHARP1” (little) or “SHARP2” (much).
To make the dialogue softer, select “SOFT1” (little) or “SOFT2” (much).
When “FLAT” is selected, no adjustment is applied.
To cancel the Surround mode
Press SURROUND MODE repeatedly until “OFF” appears.
Using the DSP Modes
(Left front speaker)
(Center speaker)
(Right front speaker)
(Left rear speaker)
(Right rear speaker)
TEST TONE L
TEST TONE C
TEST TONE R
TEST TONE RS
TEST TONE LS
TEST
4
The speaker indicators also light on the display while the test tone
comes out of the speakers.
L:
Lights when the test tone comes out of the left front speaker.
C:
Lights when the test tone comes out of the center speaker.
R:
Lights when the test tone comes out of the right front speaker.
RS: Lights when the test tone comes out of the right rear speaker.
LS:
Lights when the test tone comes out of the left rear speaker.
C
LS
L
RS
R
Notes:
• No test tone comes out of the
center speakers when
“CENTER SPK” is set to
“NONE” (see page 20).
• No test tone comes out of the
rear speakers when “REAR
SPK” is set to “NONE” (see
page 20).
• If the TV is turned on and the
proper video input is selected
on the TV, the test tone
screen will appear on the TV.
REAR L
5
6
ENTER
CNTR
2
3
MENU
REAR R
8
9
TEST
4
SHARP1
SHARP2
FLAT
SOFT2
SOFT1
CNTR
100
1k
10k
S E A
This CNTR means this adjustment can be
applied to the center speaker only.
(Example: When “FLAT” is selected.)
CNTR TONE
1
Note:
The center tone cannot be
adjusted when “CENTER SPK”
is set to “NONE” (see page 20).
Notes:
• You can adjust the speaker
output levels and center tone
without outputting the test
tone.
• You cannot adjust the center
speaker output level when
“CENTER SPK” is set to
“NONE” (see page 20).
• You cannot adjust the rear
speaker levels when “REAR
SPK” is set to “NONE” (see
page 20).
EN34_46.RX-884R[E]/1.PM5
98.3.26, 0:59 PM
41
