4
Basic connecting procedure
1 Cut, twist and remove the insulation at the end of
each speaker signal cable (not supplied).
2 Turn the knob counterclockwise.
3 Insert the speaker signal cable.
4 Turn the knob clockwise.
Connecting the front speakers
You can connect two pairs of front speakers (one pair to the FRONT
SPEAKERS
1
terminals, and another pair to the FRONT
SPEAKERS
2
terminals).
Turn the loop until you have the best reception.
Notes:
• If the AM loop antenna wire is covered with vinyl,
remove the vinyl by twisting it as shown in the diagram.
• Make sure the antenna conductors do not touch any
other terminals, connecting cords and power cord. This could
cause poor reception.
• If reception is poor, connect an outdoor single vinyl-covered wire to
the AM EXT terminal. (Keep the AM loop antenna connected.)
Connecting the Speakers
You can connect the following speakers:
• Two pairs of front speakers to produce normal stereo sound.
• One pair of rear speakers to enjoy the surround effect.
• One center speaker to produce more effective surround effect (to
emphasize human voices).
• One subwoofer to enhance the bass.
IMPORTANT:
After connecting the speakers listed above, set the speaker
setting information properly to obtain the best possible DSP
effect. For details, see page 14.
For each speaker (except for a subwoofer), connect the (+) and (–)
terminals on the rear panel to the (+) and (–) terminals marked on
the speakers. For connecting a subwoofer, see page 5.
2
1
3
4
CAUTION:
Use speakers with the SPEAKER IMPEDANCE indicated by the
speaker terminals.
AM Antenna Connections
ANTENNA
AM
LOOP
FM 75
COAXIAL
AM
EXT
2
3
1
AM Loop Antenna
Snap the tabs on the loop into the
slots of the base to assemble the
AM loop.
RIGHT
1
RIGHT
1
RIGHT
1
Left speaker
Right speaker
Right speaker
FRONT
SPEAKERS
1
FRONT
SPEAKERS
2
FRONT
SPEAKERS
RIGHT
LEFT
+
1
–
RIGHT
LEFT
2
+
–
1
2
Left speaker
Outdoor single vinyl-covered wire (not supplied)
EN01_09.RX-7010V[J]_f
00.12.6, 7:22 PM
4
