Setting up your TV
Install your TV
Power requirements
Connect the power cord only to a 220 - 240 V, 50 Hz AC outlet.
When attaching the TV to the wall, use the optional JVC wall mounting unit
Consult a qualified technician.
See the included manual on mounting procedures.
JVC assumes no responsibility for damage due to improper mounting.
Mounting holes for wall mounting unit:
M6 x 4, 400 mm x 200 mm
Depth of screw hole is 13 mm from the surface of the TV.
Installation requirements
Place the TV on the flat and stable location.
To avoid overheating, ensure the unit has ample room.
200 mm
50 mm
150 mm
150 mm 50 mm
Insert the batteries
Use two “AAA/R03” dry cell batteries. Insert the batteries from the
-
end,
making sure the
+
and
-
polarities are correct.
Subscribe to a broadcasting company beforehand. A Smart Card (B) will
be sent by the broadcasting company after subscribing to it. It may be
necessary for you to purchase a Conditional Access Module (A) in addition
to the Smart Card.
Consult your broadcasting company or retailer.
1
Unplug the power cord.
2
Insert “B” into “A”.
3
Insert “A”.
4
Plug the power cord, and turn the power on.
5
Perform necessary settings using “Common Interface”. (P. 35)
Pay-TV analogue channels cannot be watched.
Watch pay-TV digital channels
A
B
When attaching the TV to the wall
Seal up the 4 holes at the bottom of the
TV using the plates provided. Peel off the
protection films on the plates. Then peel
the plates from the paper and stick them
on the holes.
