JVC LT-32DP9BU, Инструкция по эксплуатации

Страница: 15 / 58

Setting up your TV
Start
Cancel
Step 6: Auto Scan will start when "Start" is selected
Auto Scan
Digital
13 Service Found
Analogue
51%
1 Service Found
Auto Scan
Digital
Scan Completed
13
Analogue
100%
14
Service Found
Service Found
Auto Scan
To the previous screen Æ
If the “Menu Language” does not appear or if you wish to make changes
later, refer to “Factory Setting” (P. 34) or “Retuning” (P. 34) for channel
settings.


Finish
When you cannot watch TV channels
Check the following points
Is the TV connected correctly to the aerial?
Change the direction of the indoor aerial.


Note
You can check the broadcast signal level of the channel you
are watching. For details, refer to “Signal Check” (P. 34).

Set digital channels using “Factory Settings”. For details, refer to
“Factory Settings” (P. 34)
If you still cannot watch digital channels after following the steps
above, there may be a problem with your aerial or its cable. Or, the
signal may be too weak.
Æ
Consult your retailer
Initial settings (continued)
Start auto scan
Register channels
If you can not register channels, refer to “When you cannot watch TV
channels” (P. 14).
You can edit the channels after the initial settings. For details, refer to
“Edit PR” (P. 33). To edit PR
Æ
(green)
Some digital channels cannot be watched on this TV. For details,
refer to page 40.


