English
- 16 -
To turn the TV off
Press the Standby button on the remote con-
trol unit.
The TV is in standby mode and the power
lamp lights red.
Turn off the power switch on the right side of
the TV.
The TV is turned off the main power and the
power lamp goes off.
Note:
The power switch does not fully isolate the TV
from the main power supply. To turn off the
main power supply completely, disconnect the
power plug from the AC outlet.
You can operate your TV using both the re-
mote control and TV buttons.
Operation with the buttons on the TV
Volume Setting
Press
-
button to decrease volume or
+
button to increase volume, so a vol-
ume level scale (slider) will be displayed at
the middle of the bottom on the screen.
Programme Selection
Press
button to select the next pro-
gramme or
button to select the previ-
ous programme.
Switching input mode
Pressing
TV/AV
button will change the input
mode.
Entering Main Menu
Press
MENU/OK
button to enter Main menu.
In the Main menu select submenu using
or
button and enter the sub-
menu using
-
or
+
button. To learn
the usage of the menus, refer to the Menu
System sections.
Operation with Remote Control
The remote control of your TV is designed to
control all the functions of the model you se-
lected. The functions will be described in ac-
cordance with the menu system of your TV.
Functions of the menu system are described
in following sections.
Volume Setting
Press
+
button to increase volume.
Press
-
button to decrease volume.
A volume level scale (slider) will be displayed
in the middle at the bottom of the screen.
Programme Selection (Previous or next
programme)
Press
button to select the previous
programme.
Press
button to select the next
programme.
Programme Selection (direct access):
Press digit buttons on the remote control to
select programmes between 0 and 9. TV will
switch to the selected programme. To select
programmes between 10 - 99, press the digit
buttons consecutively which programme you
want to select (eg. for programme 27, first
press 2 and then 7). When it is late to press
second digit button only the first digit
programme will be displayed. The limit of the
delay time is 3 seconds.
Example: PR6 press 6, PR12 press 1
and 2.
Press directly the programme number to
reselect single digit programmes.
Hint:
The channel list numbers are assigned by the broad-
casters. Because not all channels are broadcast free-to-air
and stored by the receiver, the channel list numbers do not
run continuously. The fifteenth channel in the list, for ex-
ample, may not be channel number 15 but channel number
17.
Hint:
If you enter a number which does not correspond to a
stored channel, the next valid channel number is selected
instead. If you enter a number greater than the highest
numbered channel in the channel list, the
DTV
will select the
last channel in the list.
A01-ENG-JVC (LT-26DY8ZG)-26815W-RMC1899S MB22 PANEU IDTV-(WO PIP)-(10052179)-5011xxxx.p65
11.09.2007, 13:50
16
