(No.MA475<Rev.001>)1-11
3.2
CD MECHANISM assembly section
• Remove the CD MECHANISM assembly from the main body.
3.2.1 Removing the MECHANISM CONTROL BOARD as-
sembly (See Fig.1 and 2)
(1) From the bottom side of CD MECHANISM assembly, re-
move the solders from the soldered sections (
a
,
b
and
c
)
on the MECHANISM CONTROL BOARD assembly. (See
Fig.1.)
(2) Remove the three screws
A
and one screw
B
attaching the
MECHANISM CONTROL BOARD assembly. (See Fig.1.)
(3) Solder the short land sections on the pickup. (See Fig.2.)
Caution:
• Solder the short land sections on the pickup before
disconnecting the flexible wire from the connector
CN102
on the MECHANISM CONTROL BOARD as-
sembly.
If the card wire is disconnected without attaching
solder, the pickup may be destroyed by static
electricity. (See Fig.2.)
• When attaching the MECHANISM CONTROL BOARD
assembly, remove the solders from the short land sec-
tions after connecting the flexible wire to the connector
CN102
on the MECHANISM CONTROL BOARD as-
sembly.
Fig.1
Fig.2
A
CN102
Mechanism
control board
A
A
B
b
a
c
Mechanism control board
CN102
Pickup
Flexible wire
Short land section
Содержание KW-XG700J
Страница 27: ......
