background image

4

Headphones (not supplied)*

4

D  

Connecting the cradle

By using the cradle (KV-CR100), you can remove the monitor from the main unit and insert it into the cradle so that the persons
sitting on the rear seat can view the playback picture even while the driver are driving your car.
• The driver must not put on the headphones while driving. It is dangerous to shut off the outside sounds while driving.
• Additional monitor (KV-MAV7001) can also be purchased to  used so that you do not need to remove the monitor from the main

unit.

KV-CR100

Main unit

Removable monitor or additional
monitor KV-MAV7001*

3

AV bus cable supplied for KV-CR100

After removing the monitor from the main unit, insert the blind
cover into the main unit to prevent internal dust accumulation.

Hold

Stereo mini plug (

 3.5 mm)

o

*

3

When not in use, store the monitor in the supplied soft case for its
protection.

*

4

To listen to source sound while in Dual Mode operations.
See page 33 of the INSTRUCTIONS (separate volume).

MULTIMEDIA DVD/CD RECEIVER WITH REMOVABLE MONITOR   HIDEAWAY UNIT    KD-AV7008

AV INPUT 1

L

R

AUDIO

FM / AM ANTENNA

POWER

BACKCAMERA

REMOTE

CENTER

SPEAKER

CENTER

SUB

WOOFER

L

R

REAR

L

R

FRONT

VIDEO

AV INPUT 2

L

R

AUDIO

VIDEO

TO CHANGER

AV BUS

TO MAIN UNIT

PRE OUT

AUDIO

VIDEO

L

R

AV OUTPUT

L

R

L

L

INPUT

INPUT

INPUT

R

L

INPUT

R

L

R

L

R

R

JVC Amplifier

Rear speakers

Front speakers

JVC Amplifier

Subwoofer

Center speaker

E

  Connecting the external amplifiers

You can connect amplifiers to upgrade surround system in the car compartment.
• Connect the PRE OUT terminals of the hideaway unit to the amplifier’s line-in terminals.

Disconnect the speakers from the hideaway unit, connect them to the amplifier. Leave the speaker leads of the unit
unused.

*

5

Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place uncoated with paint (if coated with
paint, remove the paint before attaching the wire). Failure to do so may cause damage to the unit.

*

5

*

5

*

5

*

5

F

Connecting the back camera lead

Locate the back lamp lead in the trunk.

Back lamp lead

JVC Amplifier

JVC Amplifier

If you connect the remote lead (blue with white stripe) to the remote lead of the other equipment, they can be turned on and off
automatically with this unit.

Remote lead

Y-connector (not supplied with this unit)

Remote lead (Blue with white stripe)

Hideaway unit

To the remote lead of other equipment

JVC Amplifier

Back lamps

BACK

CAMERA

To back lamp

To car battery

Back lamp lead

TROUBLESHOOTING

The fuse blows.

* Are the red and black leads connected correctly?

Power cannot be turned on.

* Is the yellow lead connected?

No sound from the speakers.

* Is the speaker output lead short-circuited?

Sound is distorted.

* Is the speaker output lead grounded?
* Are the “–” terminals of L and R speakers grounded in common?

Noise interfere with sounds.

* Is the rear ground terminal connected to the car’s chassis using

shorter and thicker cords?

Unit becomes hot.

* Is the speaker output lead grounded?
* Are the “–” terminals of L and R speakers grounded in common?

InstallKD-AV7008_2[A]5.p65

04.10.5, 3:49 PM

4

Содержание KD-AV7008

Страница 1: ...ied rating If the fuse blows frequently consult your JVC car audio dealer Maximum input of the speakers should be more than 50 W at the rear 50 W at the front and 35 W at the center with an impedance of 4 Ω to 8 Ω Be sure to ground each unit to the car s chassis The main unit and the hideaway unit become very hot after use Be careful not to get burned when removing them To prevent short circuit co...

Страница 2: ... These products are optionally available from JVC Use the extension antenna cord supplied if necessary 1 Extension AV bus cable KV U1013 not supplied can be used when the supplied AV bus cable is not long enough Black Black with white stripe Purple with white stripe 2 1 53 m m 184 m m Ÿ l s p k c A d B B INSTALLATION The following illustration shows a typical installation However you should make a...

Страница 3: ...eck the speaker wiring in your car L R L R L R Where to connect depends on your dimmer usage For details see page 46 of the Instructions PARKING BRAKE h Connecting the parking brake wire Connect the parking brake wire to the parking brake system built in the car To metallic body or chassis of the car Parking brake switch inside the car Parking brake wire light green Parking brake Contact the metal...

Страница 4: ...amplifiers You can connect amplifiers to upgrade surround system in the car compartment Connect the PRE OUT terminals of the hideaway unit to the amplifier s line in terminals Disconnect the speakers from the hideaway unit connect them to the amplifier Leave the speaker leads of the unit unused 5 Firmly attach the ground wire to the metallic body or to the chassis of the car to the place uncoated ...

Отзывы: