1-8
HX-Z3
Prior to performing the following procedure, remove
the metal cover and the CD changer mechanism
assembly.
Remove holding board by remove two plastic rivets
and then slide out the holding board as shown in fig.
12.
Disconnect fan wire from connector CN206 on the
bridge board.
Cut off the tie band that tied fan wire on inner bar.
Remove ten screws F from rear panel.
Detach joint b to release rear panel from inner bar.
Release joints c which on right bottom and left
bottom of rear panel. The joint can be release by pull
outward the side of rear panel.
1.
2.
3.
4.
5.
6.
Removing the rear panel
(See Fig.12 ~ 16)
Fan assembly will come off with rear
panel.
REFERENCE:
Fig.12
Fig.14
Fig.13
Fig.15
Fig.16
Inner bar
Inner bar
Holding board
Plastic rivets
Fan assembly
Rear panel
Rear panel
Rear panel
F
F
F
F
F
Joint c
Joint c
Fan assembly
CN206
Tie band
Joint b
Bridge board
