1-14
HX-Z3
From bottom side the CD changer mechanism
assembly,remove the four screws A retaining the CD
servo control board.
Absorb the four soldered positions a of the right and
left motors with a soldering absorber.
Pull out the earth wire on the CD changer mechanism
assembly.
Disconnect the connector CN854 on the CD servo
control board.
Disconnect the card wire CN601 and the connector
CN801 on the CD servo control board.
Remove the CD changer mechanism assembly.
1.
2.
3.
4.
5.
<CD Changer Mechanism
Type:VC3section>
Removing the CD Servo control board
(See Fig.1)
Remove the CD servo control board.
Remove the screw B retaining the lod stopper.
From the T.bracket section b and clamper base
section c , remove both of the edges fixing the rod.
Remove the three screws C retaining the T.bracket.
Remove the screw D retaining the clamper assembly.
From the left side face of the chassis assembly,
remove the one screw E retaining both of the return
spring and lock lever.
By removing the pawl at the section d fixing the
return spring, dismount the return spring.
Remove the three lock levers.
1.
2.
3.
4.
5.
6.
7.
8.
Removing the CD tray assembly
(See Fig.2~9)
b
c
E
Rod
T.Braket
Clamper base
T.Braket
Lod stopper
(C/J version only)
Clamper assembly
C
C
B
D
C
d
Lock lever
Return spring
a
a
A
A
A
A
CD servo control board
CN854
CN651
CN151
CN801
CN601
Fig.1
Fig.2
Fig.3
Fig.4
