1-15
HX-Z3
Check whether the lifter unit stopper has been
caught into the hole at the section e of CD tray
assembly as shown in Fig.5.
Make sure that the driver unit elevator is positioned
as shown in Fig.6 from to the second or fifth hole on
the left side face of the CD changer mechanism
assembly.
Manually turn the motor pulley in the clockwise
direction until the lifter unit stopper is lowered from
the section e of CD tray assembly.
Pull out all of the three stages of CD tray assembly in
the arrow direction f until these stages stop
At the position where the CD tray assembly has
stopped, pull out the CD tray assembly while
pressing the two pawls g and g' on the back side
of CD tray assembly. In this case, it is easy to pull out
the assembly when it is pulled out first from the stage
CD tray assembly.
9.
10.
11.
12.
13.
In case the driver unit elevator is not at
above position, set the elevator to the
position as shown in Fig.7 by manually
turning the pulley gear as shown in
Fig.8.
CAUTION:
CD
3
CD
2
CD
1
CD tray
assembly
e
Drive unit of elevator
CD tray assembly
f
Refer to Fig.7
Pawl
Chassis assembly
Pulley gear
Motor pulley
Pawl ,
CD tray assembly
Stopper
g
g g'
Fig.5
Fig.7
Fig.6
Fig.8
Fig.9
