38
EN
USING THE REMOTE CONTROL UNIT
(cont.)
w
M– 0 : 1 2 : 3 4
PLAY
STOP
INSERT
REW
START/STOP
PAUSE
Insert editing
indicator
Display
COUNTER R/M Button
Tape Counter
RM-V715U
(provided)
Remote sensor
Power Switch
Insert Editing
You can record a new scene onto a previously recorded
tape, replacing a section of the original recording with
minimal picture distortion at the in- and out-points. The
original audio remains unchanged.
NOTE:
Use the RM-V715U remote control unit to perform this
procedure.
1
Set the Power Switch to “PLAY”.
2
Play back the tape, locate the Edit-Out point and
press
PAUSE
.
3
Press and hold
COUNTER R/M
on the camcorder for
more than 1 second to reset the tape counter, then
press again for less than 1 second so that “M”
appears.
4
Press
REW
to go a little beyond the beginning of the
scene you want to replace, press
PLAY
to view the
recorded tape, and press
PAUSE
exactly at the Edit-In
point where the new scene should start.
5
Press and hold
INSERT
, and without releasing
INSERT
, press and release
PAUSE
. The Insert Editing
indicator appears and the Insert Editing mode is
engaged. When the scene the camcorder is aimed at
appears on the screen, go to the next step.
6
To begin Insert Editing, press
START/STOP
. When the
counter reaches “0:00:00”, editing stops automati-
cally and the camcorder enters the Insert-Pause
mode.
7
To end Insert Editing, press
STOP
.
NOTES:
●
During Insert Editing, the original audio will be heard
from the speaker.
●
After step
5
, Retake (
Z
pg. 19) can be performed.
●
The tape may stop slightly before or after the designated
end point, and noise bars may appear. Neither indicates
a defect in the unit.
●
Only the video signal is recorded in the Insert Editing
mode.
●
If Program AE (
Z
pg. 22) is set during Insert Editing,
press and hold
P. AE
for more than 1 second.
