EN
41
PL
AY
OFF
Dubbing To A Video Unit Equipped With A
DV Connector (Digital Dubbing)
It is also possible to copy recorded scenes from the
camcorder onto another video unit equipped with a DV
connector. Since a digital signal is sent, there is little if any
image or sound deterioration.
1
Make sure all units are turned off. Connect the
camcorder to a video unit equipped with a DV input
connector using a DV cable as shown in the
illustration.
2
Set the camcorder’s Power Switch to “
” while
pressing down the Lock Button located on the switch,
turn on the video unit’s power, and insert the
appropriate cassettes in the camcorder and the video
unit.
3
Press
4
to play back the source tape.
4
While watching the playback on the monitor, engage
the DV connector-equipped video unit’s record mode
from the spot on the source tape you want to begin
recording.
NOTES:
●
It is recommended to use the AC Adapter as the power
supply instead of the battery pack (
墌
pg. 9).
●
If a blank portion or disturbed image is played back on
the player during dubbing, the dubbing may stop so that
an unusual image is not dubbed.
●
Even though the DV cable is connected correctly,
sometimes the image may not appear in step
4
. If this
occurs, turn off the power and make connections again.
●
If “Playback Zoom” (
墌
pg. 44) or “Snapshot” is
attempted during playback, only the original playback
image recorded on the tape is output from the DV OUT
connector.
●
When using a DV cable, be sure to use the optional JVC
VC-VDV204U DV cable.
DV cable
(optional)
Video unit equipped with
DV input connector
To DV IN
To DV OUT
Power Switch
Core filter
Core filter
Lock Button
