2-16 (No.86700)
2.1.7.2
Adjustment of the Tension Arm and Pad Arm As-
semblies
Use Fig. 2-1-27 as the reference unless otherwise specified.
(1) Set the PLAY mode.
See Fig. 2-1-8.
(2) Loosen the screw
A
.
(3) With the take-up side at the bottom, align the extreme end
of the Tension Arm Assembly with the crossed grooves on
the screw
B
that retains the Loading Motor Assembly and
then tighten the screw
A
.
The tightening torque should be 0.069 N•m (0.7 kgf•cm).
(4) Check the operation.
Repeat unloading and loading several times and make
sure that the Tension Arm Assembly is located within the
normal range.
Fig.2-1-27
2.1.7.3
Adjustment of the Slide Lever 2
Use Fig. 2-1-28 as the reference unless otherwise specified.
(1) Set the C IN mode.
See Fig. 2-1-4.
(2) Loosen the screw
A
.
(3) Set the Main Deck and Slide Deck Assemblies apart so that
they do not rattle, then tighten the screw
A
by screwing it
fully toward the Drum Assembly.
The tightening torque should be 0.069 N•m (0.7 kgf•cm).
(4) Check the operation.
Repeat unloading and loading several times and make
sure that these operations can be performed smoothly
without producing rattles.
Fig.2-1-28
SCREW
A
SCREW
B
TENSION
ARM ASSY
(
2)(3
)
(3)
SCREW
A
(
2)(3
)
(
3)
Содержание GR-D30EK
Страница 54: ...2 43 2 44 1 2 3 4 A B C PREMDA CIRCUIT BOARD 05 PREMDA YB 10405 01 01 FOIL SIDE B ...
Страница 130: ...2 43 2 44 1 2 3 4 A B C PREMDA CIRCUIT BOARD 05 PREMDA YB 10405 01 01 FOIL SIDE B ...
Страница 224: ...2 43 2 44 1 2 3 4 A B C PREMDA CIRCUIT BOARD 05 PREMDA YB 10405 01 01 FOIL SIDE B ...